Roof Repair
The leak is traced to its source and only the failed section is rebuilt, not the whole covering.
Baltimore Roofing arranges the following work in Baltimore: flat and low-slope repair and replacement, rowhouse edges and flashing, storm inspections, leak tracing, skylights and hatches, and written reports for a sale or a claim. Each one is scoped on the roof before work begins.
Fastest: call (833) 751-2102. Or send this and we call you back.
Most of the work is on low roofs that meet neighbors at a party wall. A repair there is seldom a single fix, because the edge, the drains and the deck are connected, and a visit looks at all three before it recommends anything.
Pitched shingle roofs on the county side of the metro are also visited and scoped, and the same written-scope rule applies to them as to the flat work in the city.
The leak is traced to its source and only the failed section is rebuilt, not the whole covering.
Seams, drains and membrane laps are checked, then the failed area is rebuilt so water leaves the roof.
The old covering comes off to the deck, the boards are checked, and a new shingle system is laid over fresh underlayment.
The parapet, the party walls and the flat deck are read first, then the roof is rebuilt in sections.
Tar-and-gravel and modified bitumen systems are read ply by ply, then patched, recoated or rebuilt where they have failed.
Seams are tested, edges are terminated, and failed membrane is patched or re-laid so the sheet holds in wind and rain.
Counter-flashing is set into the mortar, caps overhang both faces of the wall, and the joint is tested before the crew leaves.
The deck, the drainage and the flashing are read first, and the scope is written before any covering comes off.
The whole roof is walked after a storm, damage is photographed and sorted, and the findings are written down.
The water path is traced from the ceiling back to the joint, and the flashing at that joint is rebuilt rather than sealed over.
The masonry is checked first, then the metal is renewed and set into the brick so water runs off the stack.
Sagging runs are re-hung and re-pitched, joints are sealed, and the outlets that serve the roof are cleared and checked.
The old unit is lifted, the curb and flashing are rebuilt to suit the roof, and the new skylight is set and water-tested.
The roof and the attic are checked, and a plain-language report sorts each finding by how soon it needs attention.
A temporary cover is sized, secured and checked over the open area, and removed when the permanent repair is made.
Seasonal checks, drain clearing and post-storm visits are set to the house, and the findings are kept in one record.
The hatch lid, its seal and frame, the access ladder and the railings are checked, and the flashing around each opening is rebuilt.
| Service | Typical range | Details |
|---|
Estimates only. Your price is confirmed on site before work starts. See the full price guide.
Tell us when you need someone and we book the earliest visit a service technician has, and you approve the price before any work starts.
Describe the symptom rather than the service. A stain, a pool of water or a storm are the usual starting points, and the visit decides which service the roof needs.
Either, depending on the deck. A sound deck can take a targeted repair or a recovering, and a soft one usually means the affected area or the whole roof is replaced.
A written report can be given to a buyer, an insurer or a lender. It records what was found, where and when, and it is dated so that it can be compared with a later one.
A temporary cover can be arranged to stop water entering while the permanent work is planned. It is photographed before and after, and it does not replace the permit or the permanent repair.