Phones answered 24/7Baltimore, MD
Call (833) 751-2102
Serving Baltimore City

Replacing an attached rowhouse roof in Baltimore

The parapet, the party walls and the flat deck are read first, then the roof is rebuilt in sections.

  • Rowhouse flat and low-slope roofs
  • Wind and storm damage
  • Parapets, cornices and flashing

Get a fast quote

Fastest: call (833) 751-2102. Or send this and we call you back.

Rowhouse Replacement

Rowhouse Roof Replacement: what it covers

Quick answer

Rowhouse roof replacement in Baltimore is the work of replacing a flat or low-slope roof on an attached house, where the roof edge sits behind a parapet or front cornice and shares walls with the neighbors. Baltimore Roofing sends the job to a local roofer who documents the cornice and the party walls before anything is removed.

Rowhouse Roof Replacement illustration for Baltimore, MD

The rowhouse is Baltimore's vernacular form. It was the main housing form in the city until the 1950s, and its roofs are unlike the pitched roofs of detached houses. An attached rowhouse typically has a flat or low-slope roof set behind a parapet or a front cornice, and the roof meets the side walls of the houses on either side. Replacing it means working inside that arrangement, not around it.

The front of the house is where the city's preservation rules bite. The Commission for Historical and Architectural Preservation treats the front cornice of an attached rowhouse as a character-defining feature, and it asks for documented deterioration before a cornice is replaced. Early rows carried low, detailed cornices. A replacement scope that touches the front edge therefore starts with a record of what is there, not with demolition.

Replacement also reaches the party walls. Where one house's roof meets its neighbor's wall, the junction is part of both jobs, and the flashing and wall cap on that line have to be laid out on each side. A careful roofer marks which junctions will be opened, so the neighbors can be told before anything comes down.

Service area
Baltimore & Baltimore City
Availability
Phones answered 24/7
Warning signs

Signs you need rowhouse roof replacement

A rowhouse roof is reached from the top floor or a ladder, and its parapet can be a fall edge. Keep guards in place around open edges, do not lean on a cracked parapet, and do not stand on a surface until the deck has been checked. Masonry may be loose above the work, so keep the sidewalk clear below. For any work on the roof edge, call (833) 751-2102 and let a roofer set up the access.

  • Ponding in the same low spot after most storms, with a dark ring left behind
  • Blisters or open laps along the rear and side walls where the roof meets masonry
  • Parapet mortar cracked or crumbling, with water tracking down the inside of the wall
  • Staining on the top-floor ceiling or on the front wall above the cornice
  • Surfacing that gives underfoot in several places across the roof
Job stories

Typical jobs for rowhouse roof replacement

Typical job
Illustration: A typical recovering question on an older rowhouse in Baltimore

A typical recovering question on an older rowhouse in Baltimore

What homeowners notice
An owner plans to lay a new covering over an existing flat roof to avoid the cost of a full strip. The roofer is asked whether that is sensible, and the answer depends on what is underneath.
What we do
The roofer lifts the edge at the parapet to count the coverings and checks the attic side of the deck. The count is higher than the owner expected, and one section of the deck shows staining near a drain. The roofer writes a scope that strips the roof to the deck in the stained area, with an allowance for the boards and a photograph before and after.
What to expect
The owner receives a scope that lays out the two options side by side, with the weight of the layers and the deck allowance named for each. The owner chooses the full strip and keeps the count and the photographs with the house papers.

Options

Types and options for rowhouse roof replacement

Cornice and parapet rebuild

The front cornice or parapet is repaired or rebuilt where its mortar, brick or metal has failed. Work on the historic front is recorded and, where the building requires it, reviewed before any stone or brick is replaced, so the rebuilt edge matches the house beside it.

Membrane over a sound flat deck

A single-ply or modified membrane is laid over a sound deck, lapped at every seam and finished at each edge. The membrane type is chosen from the deck, the drainage and the access to the roof, not out of habit.

Full tear-off to the deck

Where the layers are failing, all of them come off and the deck is rebuilt. This is the most disruptive option for the house and its neighbors, and it is the one that allows the deck itself to be corrected at the source.

Rear addition junctions

Many rowhouses have a rear addition whose roof sits at a different height. The junction where a flat addition meets the main house is a common leak point, and it gets its own flashing detail and its own line in the scope.

Still stuck? We pick up 24/7.

If it's an emergency, call now. For non-urgent rowhouse roof replacement, send the form and we'll call you back.

Why the parapet and the cornice come first

The roof edge is the most sensitive part of an attached house, so a roofer starts the scope there.

A parapet or cornice is both a weather barrier and part of the facade. Before a roofer removes any coping or metal, the condition of the masonry is recorded: cracks, loose brick, failed mortar and any metal flashing set into the wall. Those notes matter to the homeowner and, where the house sits in a historic district or is a landmark, to the review that may apply.

Work at the edge also has to keep water out of the wall while it is open. Temporary covers and a sequenced removal keep the masonry dry through the job. The edge is rebuilt with new flashing set into the wall, not with sealant laid on the surface, so the joint sheds water from behind the coping.

Party walls and shared junctions

Where the roof meets a neighbor's wall, the flashing and the cap decide whether water reaches the top floor.

The party wall is often where a rowhouse roof leaks first, because it is the junction that moves with the masonry, and the flashing must tolerate that movement. A new cap is set so it overhangs both faces of the wall and drains outward, and the flashing is set into a reglet cut in the mortar joint rather than laid across the surface.

Neighbors are not part of the contract, but their wall is part of the work. A roofer who gives notice before working near the shared line avoids disputes and leaves the joint in better shape for both houses.

  • Counter-flashing set into a cut in the mortar joint
  • A cap or coping that overhangs both faces of the wall
  • A drip at the outer edge of the parapet
  • Written notice to neighbors before the joint is opened

Reading the flat deck and its layers

The deck is read by testing it, not assumed from the surface, because the layers beneath show what was done before.

Once the surfacing is cut through at test points, the layers beneath reveal their history. Some rowhouse roofs carry a sound membrane over an earlier surface, and some carry a deck that has stayed dry because its drainage has always worked. Each layer is logged, its condition is noted, and the decking below is checked for soft or rotten boards.

The decision about what to remove follows from those findings. A roofer does not assume the old layers can be left, and does not assume they must all go. The scope names the condition found, and the homeowner sees that reasoning in writing before the removal starts.

Rebuilding the flat roof with a sound system

A rebuilt rowhouse roof is only as good as its drainage, its edge and its membrane seams.

The deck is cleaned, dried and tapered toward its outlets where the slope allows, so water is carried away rather than held. A cover board is set if the design calls for one, and the membrane is laid, bonded and sealed at every lap, edge and penetration. The edge is finished with metal set into the masonry.

A new roof is only finished when its outlets work. Each drain, scupper or gutter connection is tested with water on the day of completion, so the homeowner has seen the water leave the roof before the crew packs up.

Our process

How our rowhouse roof replacement visit works

  1. Survey the front and the parapet

    The cornice and parapet are photographed and measured, and loose masonry, cracks and failed metal are marked. The findings are kept in the file so the front of the house can be compared before and after the work, which matters for any review that applies to the building.

  2. Check the party walls and the neighbors

    The shared junctions are identified and the notice to neighbors is prepared. Where a neighbor's wall carries the flashing, the roofer plans the work from the house's own side and says in advance what will be opened.

  3. Protect the masonry and the rooms below

    Temporary covers keep rain off open masonry, and the top-floor ceiling is protected from dust and water. The area beneath the roof is cleared, and the stairwell is kept dry for the length of the job.

  4. Remove the surface and test the deck

    The surfacing and membrane come off in sections, the deck is probed, and any soft or rotten boards are replaced. Outlets are cleared, and drainage is checked again with the old roof gone, since the slope of the bare deck is easier to read.

  5. Rebuild the edge and test the outlets

    The new membrane is laid and sealed, the edge metal is set into the masonry, and each outlet is tested with water. The site is cleaned, and the homeowner receives a record of the layers and of the edge detail.

Baltimore City

Why rowhouse roof replacement is different in Central Maryland

Attached rowhouses in Baltimore commonly have a flat or low-slope roof behind a parapet or cornice. The city's preservation staff have asked for documented deterioration before a front cornice is replaced, as recorded in Commission for Historical and Architectural Preservation staff reports and hearing minutes. A roofer who does not document the front before work begins is not doing the job the city expects.

A permit is required before a structure is repaired, altered or rehabilitated, under Baltimore City Code, Building Code Article II section 105. Historic districts and landmarks have separate triggers, so a rowhouse inside one may need review before the cornice is touched.

Baltimore is an independent city, in no county, so the rules described here are city rules. Dundalk, for example, is in Baltimore County just outside the city line, and a roof there falls under county requirements that this page does not cover.

Related

Roof Replacement

The deck, the drainage and the flashing are read first, and the scope is written before any covering comes off.

Parapet and Party Wall Flashing

Counter-flashing is set into the mortar, caps overhang both faces of the wall, and the joint is tested before the crew leaves.

Flat Roof Repair

Seams, drains and membrane laps are checked, then the failed area is rebuilt so water leaves the roof.

Guides

Read before you book

FAQ

Rowhouse Roof Replacement FAQs

Can I replace only the rear section of a rowhouse roof?

Sometimes. A rear section can be replaced where it is separated from the front edge and the drainage allows it. The junction with the front parapet and the party walls then needs its own detail, and the scope spells it out.

Will the front cornice have to be rebuilt?

Only if its condition requires it. The first step is a documented survey. A sound cornice is repaired and re-flashed rather than replaced, and any replacement is recorded in detail before work begins.

Does a rowhouse roof always need to come off?

No. A sound membrane over a sound deck can be repaired or overlaid, and the decision depends on what the layers and the deck show. A roofer who recommends full removal should explain the findings that lead there.

What about the neighbors?

Work on a shared junction affects the house next door. Notice before the joint is opened is good practice, and the roofer should plan the work so the neighbor's wall is not left open to weather.

How do I know the drainage is right?

The outlets should be tested with water before the crew leaves. Watching the water run to each drain tells you more than a visual check of a flat surface, so ask to see it done.

Is a permit needed?

In Baltimore City, yes, for work that repairs or alters a structure, under Building Code Article II section 105. Ask the roofer to confirm the permit is pulled before the cornice or the deck is opened.

WhatsApp