Phones answered 24/7Baltimore, MD
Call (833) 751-2102
Serving Baltimore City

Replacing the whole roof of a Baltimore home, from deck to ridge

The deck, the drainage and the flashing are read first, and the scope is written before any covering comes off.

  • Rowhouse flat and low-slope roofs
  • Wind and storm damage
  • Parapets, cornices and flashing

Get a fast quote

Fastest: call (833) 751-2102. Or send this and we call you back.

Roof Replacement

Roof Replacement: what it covers

Quick answer

Roof replacement in Baltimore means taking the whole covering off a house, or a whole plane of it, and rebuilding the deck, underlayment, flashing and surface to a current standard. It is chosen when the failure is widespread rather than local. Baltimore Roofing sends the job to a local roofer who sets the scope from the decking and the layers, not from the age of the roof alone.

Roof Replacement illustration for Baltimore, MD

Most homeowners arrive at a replacement after a run of smaller repairs. A leak is patched in one place, a valley is re-cut the next year, and a section of flashing is resealed the year after that. Repairs stop helping when they keep appearing in new places. Replacement is the decision that follows when the roof is failing as a whole, and the question then becomes how to make the new roof durable rather than simply new.

Age is a poor guide on its own. A roof of a given age can be sound over a good deck, or nearly finished over a worn one. The decking, the number of coverings, the flashing and the drainage decide the scope. Baltimore's housing spans many decades, and by one set of Census-based estimates roughly two in five homes were built before 1940, so neighboring houses can carry roofs of very different vintage and condition.

Replacement is a larger job than repair, and it is also the best moment to correct whatever made the old roof fail. A roofer who replaces the covering without checking the deck, the drainage and the attic ventilation has only reset the clock. A good scope names each of those points and says what will be done about them before any work begins.

Service area
Baltimore & Baltimore City
Availability
Phones answered 24/7
Warning signs

Signs you need roof replacement

A roof replacement exposes the deck and the edges for days at a time, and the work is physically demanding. Crews should use fall protection, stage material away from the edges and keep the drop zone clear of people and pets. Homeowners should keep out of the work area and avoid walking any part of the roof while the covering is off. Call (833) 751-2102 to arrange the scope and the access.

  • Repairs appearing in a new place after each heavy rain, though the old ones are sound
  • Granules in the gutters and bare, smooth patches across the sun-facing slope
  • Several coverings found when one area is lifted, with the lower one brittle
  • Soft or springy boards when a section is probed from the attic side
  • Flashing that has been resealed more than once at the same joints
  • A roof that sheds water poorly, with ponding in the valleys after rain
  • Daylight through the decking near the eaves when the attic is dark
Options

Types and options for roof replacement

Full replacement of a pitched roof

Every plane of the roof is taken off to the deck and rebuilt. This is the most complete option and the simplest to scope, since the whole deck, edge and flashing package is renewed together and nothing is left to age beside the new work.

Replacement of selected planes

When only some planes have failed, those planes can be rebuilt while the rest are kept. The junctions between old and new work get careful flashing, and the change in tone is taken to a ridge or valley where possible so it falls on a natural line.

Replacement of a flat section

A low-slope section of a roof is rebuilt with membrane or built-up material, while the pitched sections are dealt with separately. The two systems meet at a wall or curb, and the meeting detail is the part to read most closely in the written scope.

Replacement with a new deck

Where the sheathing is soft across a broad area, the deck itself is replaced before the covering goes on. The new boards are fastened to every rafter, and the framing is checked at the wall plate and ridge, so the roof bears its load from the start.

Need roof replacement today?

Call any hour and explain what is going on. You get a clear price before any work starts.

Deciding between repair and replacement

Replacement is the better choice when the failure is spread across the roof, not when it sits at one point.

A repair is sensible when the rest of the covering has life left and the fault is local. Replacement makes more sense when wear appears on every slope, when the deck is soft in several places, or when the flashing has been reworked so often that the joints have lost their original form.

The decision should rest on findings rather than on a number of years. The roofer explains what was seen on the deck, in the layers and at the flashing, and the homeowner can weigh that explanation against the house as it stands.

What the scope has to cover

A written scope lists each part of the roof, what is done to it and why, so nothing is left to be decided on the day.

The scope is the working document for the whole job. It should be specific about the deck and the boards to be replaced, and it should name the underlayment type and how it is lapped. A vague line such as renew flashing tells the homeowner little, while a line that names the wall, the chimney or the vent and the metal to be used tells them exactly what will happen.

It should also cover the attic. Ventilation at the ridge and eave, the balance between them and any penetrations that are being re-flashed belong in the scope, because they affect how the new roof performs in summer and winter.

  • Deck condition and each board to be replaced
  • Underlayment type and the lap at each course
  • Flashing at every wall, chimney and vent
  • Attic ventilation at the ridge and the eave
  • Drainage at the eave, the valleys and any outlet

Warranties and the paperwork that follows

The paperwork is part of the job. A homeowner should leave with a record that says what was installed and what the installer promises.

Any warranty the installer offers should be handed over in writing, with a clear statement of what it covers and for how long. Read it before the crew leaves, and ask about any term that is unclear, because the terms decide what happens if a problem appears later.

The record should also include the product name and color, the location of each flashing detail and a sketch of the roof. A future roofer will need those facts to repair the work and to match a new covering if one is ever needed.

Timing the work around the weather

Replacement can be stopped by rain, so the roofer should say in advance what happens when the weather turns mid-job.

A roof is open for the length of the job, and an open deck is exposed to rain. A good roofer covers the exposed area each evening, dries the deck before laying material over it, and keeps the rest of the roof sealed so a shower does not reach the rooms below.

Homeowners should ask how the crew handles a forecast storm. The answer should cover covering the open area, pausing the work safely and the order in which sections are finished, so the house is never left without protection overnight.

Protecting the house during the work

The yard, the attic and the rooms below all need protecting before the first board comes up.

Plants, paths and parked vehicles are cleared from the drop zone, and a magnetic sweep and debris container are set in place. Attic openings are sealed against dust and nails, and the top-floor ceiling is covered where the work sits directly above it.

Gutters are cleared before the job starts and checked again when it ends, because the old covering sends a great deal of grit into the drains while it is being removed.

Our process

How our roof replacement visit works

  1. Inspect the deck and count the layers

    The roofer checks the edges, vents and any opened area to find the number of coverings and what the sheathing is made of. The attic side is inspected for staining, rusted nails and dark rafters, so the deck is judged from both faces.

  2. Agree the scope in writing

    The scope lists every part of the roof, what will be done to it and the reason for each step. It is agreed before the crew arrives, so the homeowner knows what the work is and what might change if the decking proves worse than expected.

  3. Remove the covering and the failed deck

    The roof comes off to the boards in sections, with flashing removed at the same time. Soft or failed sheathing is cut out and replaced, and each rafter end is checked where it bears on the wall plate.

  4. Rebuild the drainage and the ventilation

    Underlayment and drip edge are laid to carry water to the eave, valleys are lined with metal, and the attic ventilation is set so air can move through the space. Those details are the part a homeowner cannot see later, which is why they are written into the scope.

  5. Lay the new surface and close out

    The new covering goes on to the plan, the flashing is finished at each junction, and the roof is walked with the homeowner. Any warranty from the installer is handed over in writing with a sketch of the roof showing where each detail sits.

Baltimore City

Why roof replacement is different in Central Maryland

Baltimore is an independent city, in no county. A roof replacement within the city line falls under Baltimore City Code, Building Code Article II section 105, which requires a permit before a structure is repaired or altered. Permit amounts and inspection stages are not covered on this page.

A house in Towson, Catonsville or Dundalk is in Baltimore County, not in the city, and the city code cited here does not reach it. County permit rules are not covered on this page, so ask the roofer which requirements apply at the address.

Replacement on an attached rowhouse has its own front-edge rules. The city's preservation staff treat the front cornice as a character-defining feature, so a replacement scope that touches the front edge begins with a documented record of its condition.

Related

Shingle Roof Replacement

The old covering comes off to the deck, the boards are checked, and a new shingle system is laid over fresh underlayment.

Rowhouse Roof Replacement

The parapet, the party walls and the flat deck are read first, then the roof is rebuilt in sections.

Storm Damage Roof Inspection

The whole roof is walked after a storm, damage is photographed and sorted, and the findings are written down.

Roof Maintenance Plan

Seasonal checks, drain clearing and post-storm visits are set to the house, and the findings are kept in one record.

Guides

Read before you book

FAQ

Roof Replacement FAQs

How do I know whether the whole roof needs replacing?

Ask the roofer to show the deck, the layers and the flashing findings, and then ask whether the faults are local or widespread. A roof that fails in several places across its planes is usually a replacement, while a single failed area is a repair.

Will the new roof be laid over the old one?

That depends on what the old layer and the deck show. A sound, flat covering can sometimes be worked over, but a roof with soft decking or several layers is normally stripped back to the boards. The scope should state which approach is proposed and why.

Should the attic ventilation be changed as part of the job?

It should be checked, and changed where the design calls for it. Ventilation that is out of balance ages the new roof from inside, so the roofer looks at both the intake and the exhaust before setting the covering.

What if the roofer finds rot after the old roof is off?

Rotten or soft sheathing is replaced to the nearest rafter, and the homeowner should have agreed in advance how that is handled. A scope that names the possibility avoids an argument on the day the boards are exposed.

How long should the homeowner stay in the house during the work?

Most people stay put, since the crew works outside the rooms. The main requirement is access to the attic and the yard and a way to be reached if a decision comes up, such as a soft board or an unexpected flashing detail.

Is a new roof a good time to add a skylight or a vent?

It can be, because the deck and the covering are already open. Any new opening should be planned in the scope so its flashing is built with the roof rather than patched in afterward, and it should be checked for the same water test as any other joint.

WhatsApp