What a maintenance visit covers
A visit covers the covering, the flashing, the drainage and the attic side, with the same method each time so the record stays comparable.
The covering is looked at for lifted tabs, cracks, granule loss and nail heads that have backed out. The flashing is checked at each wall, chimney, vent and skylight, and the sealant lines are tested for splitting. The drainage is cleared and its flow confirmed, and the edge metal is checked for any bend or gap.
The attic side is part of the visit where access allows. Staining, damp insulation and rusted fixings are noted, and any change since the last visit is recorded. Using the same order each time makes the changes easier to see, which is the main benefit of a routine.
- Covering: lifted tabs, cracks and backed-out nails
- Flashing and sealant at each wall, chimney and vent
- Gutters, outlets and scuppers cleared and flowing
- Attic side checked for staining and damp insulation
Seasonal timing without fixed dates
The calendar follows the house and the weather it faces, so the visits fall when they are most useful rather than on a fixed date.
Many roofers set visits before the heaviest rain and again after the leaves have fallen, since both are times when drainage is most likely to be tested. The right calendar for a particular house depends on its trees, its exposure and the kind of roof it carries, and it is set with the homeowner rather than printed on a card.
A calendar that is kept is worth more than a perfect one. A plan that is agreed and then missed lets faults grow unseen, so the roofer should book the next visit at the end of each one and confirm it in writing.
Gutters and outlets as the first defense
Clean drainage protects the covering and the edge, and it is the simplest part of a maintenance routine to keep working.
Blocked gutters and outlets hold water against the edge of the roof and the top courses of the covering. Over time that water soaks the fascia and works under the membrane or the shingles, and it is one of the most common ways a roof fails from the edges inward.
On flat sections, the outlets and scuppers are the critical parts. Their strainers are cleared, their flow is tested, and their height is checked against the low point of the roof, since an outlet set above the surface holds water in place however often it is cleared.
Keeping records a future roofer can use
The record is the part of the plan that outlives the visits, so it is written for a stranger who has to pick up the work later.
Each entry should give the date, the area, what was seen, what was done and a photograph. Entries should be short and precise, because a future roofer needs to find a repair quickly and understand what it was meant to do.
The record belongs to the house. If the property changes hands, the homeowner should hand it on with the other papers, so the next owner knows what the roof has been through and what it was last asked to do.