When a temporary cover is the right call
A cover is the right step when water is entering, the opening is exposed and the permanent repair cannot be made at once.
A cover is for openings that are letting water in or are about to, and it is the right answer when a permanent repair has to wait for materials, a dry window or a crew. It is not the right answer for a roof that is only slightly damaged, which can be checked and left until the next scheduled visit.
The homeowner should not wait for the water to reach the ceiling before calling. A cover put on the same day is far simpler than a repair to the ceiling and insulation a few days later, and the roofer can say whether the opening is urgent or can safely wait.
How a cover is fitted safely
A cover is fitted from a safe access point, sized to the opening and secured so that it does not lift or flap.
Fitting a cover on a storm-damaged roof is dangerous work. The surface may be slippery, the decking may be weakened and debris may be hidden under the covering. The roofer works from a secure access point, moves carefully across the sound areas, and avoids standing on any soft board or exposed opening.
The cover is laid with its upper edge tucked under the sound covering above the opening and its lower edge free, so water runs over the sheet rather than behind it. The sheet is kept tight and flat, and its fixings are placed in sound material rather than in the damaged area.
- Secure access point and a second person at the base
- Upper edge tucked beneath the sound covering
- Lower edge left free so water runs over the sheet
- Fixings placed in sound material away from the opening
Securing the cover against wind
A cover that is not secured will lift in the first gust, and a lifted cover can tear more covering than the storm did.
Wind is the main threat to a temporary cover. Battens or boards along the edges hold the sheet down, and weights such as sandbags are placed where the edges could lift. The fixings are kept to the minimum needed, since every new hole is another point for water to enter.
Once the cover is in place, its edges are checked after each change in the weather. A cover that has begun to flap or pull free is re-secured promptly, because a cover that has failed in a storm is a bigger problem than the opening it was meant to hold.
Removing the cover and what follows
A cover is removed when the permanent repair is made, and the repair is checked to confirm it has replaced what the cover was holding back.
The permanent repair is planned from the damage the cover is protecting. The roofer records what is under it, measures the opening and books the work, so that the cover is in place for the shortest time needed. When the repair is made, the cover is removed and the surface beneath is checked.
The repair is confirmed with a water test, just as any new joint is. The cover should not be removed until the new work is sound, and the homeowner should receive a note of what was done and where the repair sits on the roof.