Water that shows on an upper ceiling may come from the roof, from the parapet or cornice above, or from the brick wall it runs down. On a masonry rowhouse the three can be hard to separate, so the useful test is where the water enters, not where it appears. Formstone is named here only as a facing, and no roof claim is made about it.
Key takeaways
- Water seldom appears directly beneath the place it enters, because it travels along framing, deck and masonry before it shows.
- A leak that follows wind-driven rain points toward the flashing and the parapet, while a stain that follows any rain may point to the wall.
- The parapet, the cornice cap and the junction with a party wall are the three places where roof and wall meet on a rowhouse.
- A stain on a decorative facing is not, by itself, evidence of a roof fault.
- A simple test in rain, inside and outside, separates most of these leaks before any opening is made.
- Roofers and masons often work on different parts of the same leak, so the scope should say which trade does which part.
Why do roof and wall leaks look alike inside?
Both produce a stain on the ceiling or the top-floor wall, and the mark is often well away from the point where the water entered.
Water follows the path of least resistance through the building. It can run along a rafter, across a joist or down the inside face of a masonry wall before it finds a gap large enough to drip, and the stain appears where the path ends rather than where the water came in.
On a masonry rowhouse the wall is thick and holds moisture for a long time. Water that enters at the top can travel down the inside of the wall and show low on a room wall, long after the rain has stopped, which is why a stain low down does not automatically mean the leak is at the bottom.
The useful question is therefore not where the stain is but when it appears. Note the weather that produced it, the wind direction if you can judge it, and whether it dried quickly or slowly. Those details narrow the search before anyone climbs a ladder.
What does the parapet do?
The parapet is the low wall that rises above the roof edge on a flat rowhouse roof. Its cap and the flashing where it meets the roof are among the most common places water enters the building.
A parapet is exposed on both sides. Water runs down the outer face of the wall and sits at the joint where the cap meets the masonry, and it can run into the top of the wall through cracked mortar or a gap in the cap. The water that gets in there can reach the top floor without touching the roof surface at all.
The flashing where the roof membrane turns up the inside of the parapet is the second weak point. It is a joint between two materials that expand and move differently, and a lifted or split flashing lets water pass behind the covering and into the wall.
A leak at the parapet often appears on the wall nearest to the roof edge and on the top-floor ceiling. Check the cap, the mortar joints and the flashing before assuming the field of the roof has failed, because the field is often the last place water finds its way in.
What is the brick wall's part in the leak?
A masonry wall can leak on its own, through cracked mortar, open joints or water running down its face. A wall leak is a separate fault from a roof leak, and it needs a separate repair.
Brick and masonry absorb rain and release it slowly. A wall that is weathered, with open joints or cracked mortar, can let water into the building during a driving rain, even when the roof above it is sound. That water often shows on the wall rather than on the ceiling.
A wall leak tends to appear during wind-driven rain from one direction, and it may show on the side of the house that faces that wind. A roof leak more often follows the rain generally, and it is more likely to show on the ceiling of the top floor.
Repointing and sealing a wall are masonry tasks. A roofer who finds that the leak is in the wall should say so, and the scope should name who does the mason work, who is responsible for the joint between the trades and whether a permit applies to the masonry repair.
What role does formstone play?
Some rowhouse fronts are faced with formstone, a decorative masonry-look facing. The sources used for this page do not link formstone to roof performance, so no roof claim is made here.
Formstone is named here only in passing, as a facing on some rowhouse fronts. A stain or a crack on a facing is a visible surface condition, and it can be caused by water that entered elsewhere, by movement in the wall or by the facing itself.
A stain on a facing is not, on its own, evidence that the roof is leaking, and a roof repair is not a fix for a facing defect. Where a leak is suspected, the question to answer is where the water enters, and the facing is only one of several places to check.
If you are unsure whether a facing defect is connected to a leak, photograph it in rain and after rain, and ask a roofer or a mason to look at it with you. The record is more useful than a decision made on the strength of a single stain.
Which signs point to the flashing?
A leak that appears after wind-driven rain, close to the party wall or the parapet, and that dries slowly from the same spot, points toward the flashing at the roof edge.
Flashing leaks show a pattern. The water appears at the same point each time, usually where the roof meets the wall or where the parapet turns, and it appears more after rain that is blown against the building than after gentle rain from above.
A stain at the party wall, close to the junction with a neighbor's roof, is a common sign of flashing failure, because that junction moves with both buildings and is rarely checked. Such a stain should be photographed and reported to the roofer, not left to the neighbor to explain.
Check the flashing from the roof when it is safe to go up, and look for lifting, splitting or a gap in the sealant. A flashing repair is usually local and quick, and it is the repair that is most often missed when the field of the roof is replaced without the edge being opened.
Which signs point to the wall?
A stain low on a room wall, a damp line that climbs or drops with the weather, or a crack in the mortar on the side facing the wind suggests the masonry is taking the water.
A wall leak often shows as a damp patch that spreads slowly and does not dry for days. It may be strongest after a long rain rather than a short storm, because the masonry has to be saturated before the water finds its way through.
Look at the outside of the wall after rain. Open or cracked mortar, staining that runs down from a joint, and a gap where the wall meets a window frame or a chimney are all clues. Photograph them in rain if you can, because the wet joint shows its failure more clearly than a dry one.
Ask the roofer and the mason to look at the wall together when the leak is unclear. A joint inspection costs little compared with replacing a roof that was never the source of the water, and it protects both trades from being blamed for the other's fault.
What simple test separates the two?
Observing the leak during rain, inside and outside, with the time and the wind direction noted, separates most roof and wall leaks before any opening is made.
Inside, mark the edge of any stain with a pencil and the date, and note the time when water first appears. Put a dry cloth or a container under the drip and check it during the next rain, so you can see whether the water is coming down or running along.
Outside, go to the wall at the same time, if it is safe to do so from the ground, and look at the joints and the cap while it rains. Water running down a wall face from a cracked joint is different from water coming through the parapet cap at the top, and the difference is visible from a short distance.
Record the results in a short note with photographs and the weather. A two-column record, one column for roof observations and one for wall observations, makes the next conversation with a roofer and a mason much shorter. A short note made on the day is worth more than a longer one written from memory.
How should the repair be divided between trades?
The roofer repairs the covering, the flashing at the roof edge and the parapet membrane. The mason repairs the wall, its mortar and its cap. The scope should say which trade does which part and who coordinates them.
A repair that crosses the line between roof and wall is the one most likely to be left half-finished. A roofer who seals the flashing and a mason who repoints the joint above it have each done part of the job, and neither has to fix what the other has done unless the scope says so.
The coordination is the owner's responsibility unless it is assigned in writing. Ask who will attend first, who will confirm that the other trade has finished, and how the leak will be tested after both repairs are complete. Put the agreed split in writing before either trade begins.
Whether a permit applies to masonry work as well as roof work is a question for the Building Official. Baltimore City Code requires a permit before a structure is repaired or altered, so the scope should say who applies and when, for each part of the work.
Frequently asked questions
Can a roofer fix a leak that is coming through the wall?
Possibly, at the junction with the roof. A wall repair, such as repointing or a new cap, is often a masonry job, so ask who will carry it out and how the two trades will coordinate.
Does a stain on the facing mean the roof is failing?
Not by itself. A stain on a facing can have several causes, and the sources used for this page do not connect formstone to roof performance. Test for the point of entry before deciding on the repair.
Is the leak more likely from the roof or the wall after a storm?
It depends on the pattern. Leaks that follow wind-driven rain and appear near the parapet or party wall point to the flashing. Damp that spreads slowly and climbs or drops with the weather points more to the masonry.
Do I need a permit to repair brick or a parapet?
Baltimore City Code requires a permit before a structure is repaired or altered. Ask the roofer or the mason who will apply, and whether the work touches a historic district or a landmark.
What is the first thing to do when the stain appears?
Mark its edge with a pencil and the date, put a cloth or container beneath any drip, and photograph the stain. Then note the weather and call a roofer who will test both the roof and the wall.
Sources
This guide is general information for Baltimore City homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.